混凝土搅拌机不会转了是怎么回事？
混凝土搅拌机不会转了是怎么回事？下面中科搅拌机就教大家遇到这种情况该怎么办。
What's wrong with the concrete mixer? Next, we will teach you how to do in this situation.
1、混凝土搅拌机应设置在平整的位置，用方木垫起前后轮轴，使轮胎搁高架空，避免在开动时发作走动。
1. The concrete mixer should be set in a flat position, and the front and rear axles should be padded with square wood to make the tires empty, so as to avoid moving when starting.
2、混凝土搅拌机应实施二级漏电维护，上班前电源接通后，有必要仔细检查，经空车试转认为合格，方可运用。试作业时应检验拌筒转速是否合适，一般状况下，空车速度比重车（装料后）稍快2~3转，如相差较多，应调整动轮与传动轮的份额。
2. The concrete mixer shall be subject to secondary leakage maintenance. After the power supply is connected before going to work, it is necessary to check carefully, and the mixer can be used only after passing the test run without load. During the trial operation, it is necessary to check whether the speed of mixing drum is appropriate. In general, the speed of empty car is slightly faster than that of truck (after loading). If there is a large difference, the share of driving wheel and driving wheel should be adjusted.
3、拌筒的旋转方向应契合箭头指示方向，如不符实，应更正电机接线。
3. The rotation direction of mixing drum shall be in accordance with the direction indicated by the arrow. If not, the motor wiring shall be corrected.
4、检查传动离合器和制动器是否灵活可靠，钢丝绳有无损坏，轨道滑轮是否杰出，周围有无妨碍及各部位的光滑状况等。
4. Check whether the transmission clutch and brake are flexible and reliable, whether the wire rope is damaged, whether the track pulley is outstanding, whether there are obstacles around and the smoothness of various parts.
5、开机后，常常注意混凝土搅拌机各部件的作业是否正常。停机时，常常检查混凝土搅拌机叶片是否打弯，螺丝有否打落或松动。
5. After starting up, pay attention to the normal operation of each part of the concrete mixer. When stopping the machine, often check whether the blades of the concrete mixer are bent and whether the screws are broken or loose.
6、当混凝土搅拌完毕或预计停歇1h以上，除将余料出净外，使用石子和清水倒入抖筒内，开机转动，把粘在料筒上的砂浆冲洗干净后悉数卸出。料筒内不得有积水，避免料筒和叶片生锈。同时还应整理搅拌筒外积灰，使机械保持清洁完好。
6. When the concrete mixing is finished or it is expected to stop for more than 1 h, in addition to discharging the remaining materials, the stone and water are poured into the shaking drum, and the machine is started to rotate. After the mortar glued to the barrel is washed, all the mortar is discharged. There should be no water in the barrel to avoid rust of the barrel and blade. At the same time, the dust accumulation outside the mixing drum should be sorted out to keep the machinery clean and intact.
7、下班后及停机不用时，应拉闸断电，并锁好开关箱，以确保。
7. After work and when the machine is not in use, the switch should be switched off and the switch box should be locked to ensure safety.
在对混凝土搅拌机进行清洗时应注意以下事项：
Attention should be paid to the following matters when cleaning the concrete mixer:
一、定时进行保养规程所规则项目的维护、保养作业，如清洗、光滑、加油等
1、 Regularly carry out the maintenance and maintenance work of the items regulated by the maintenance regulations, such as cleaning, smoothing, oiling, etc
二、混凝土搅拌机开动前要先检查各控制器是否杰出，罢工后用水和石子倒入搅拌筒内10~15分钟进行清洗，再将水和石子清出。操作人员如须进入搅拌筒内清洗时，除切断电源和卸下熔断器外，并须锁好开关箱。
2、 Before starting the concrete mixer, check whether the controllers are outstanding. After the strike, pour water and stones into the mixing drum for 10 ~ 15 minutes for cleaning, and then clear the water and stones. If the operator needs to enter the mixing drum for cleaning, in addition to cutting off the power supply and removing the fuse, the switch box must be locked.
三、制止用大锤击打的方法铲除积存在混凝土搅拌机筒内的混凝土，只能用凿子铲除。
3、 It is forbidden to remove the concrete accumulated in the concrete mixer barrel by hammering. Only chisel can be used.
四、在严寒季节，作业完毕后使用水清洗搅拌机滚筒并将水泵、水箱、水管内积水放净，避免水泵、水箱、水管等冻坏。
4、 In severe cold season, use water to clean the mixer drum after operation, and drain the accumulated water in water pump, water tank and water pipe to avoid freezing damage of water pump, water tank and water pipe.
以上是混凝土搅拌机操作时的检查和清洗事项的相关介绍，相信大家都已知悉，想要了解更多内容请继续关注中科搅拌机https://www.jfjiaobanche.com官网。
The above is the concrete mixer operation inspection and cleaning matters related to the introduction, I believe you all know, want to learn more, please continue to pay attention to the Zhongke mixer https://www.jfjiaobanche.com Official website.
