自上料搅拌车使用功能与进出料的事项
自上料搅拌车使用功能：
Function of self-feeding mixer:
自上料搅拌车应安装在坚实平整的地面上，防止因地面下陷发生倾倒。
The self-feeding mixer shall be installed on a solid and flat ground to prevent tipping due to ground subsidence.
自上料搅拌车厂家建议，在使用作业前，应按清洁、紧固、润滑、调整、防腐的程序检查机器各系统，并使之符合要求；有事故隐患须及时。
The manufacturer of the self-feeding mixing truck suggested that before use, all systems of the machine should be checked according to the procedures of cleaning, fastening, lubrication, adjustment and corrosion prevention, and make them meet the requirements; Any potential accident must be eliminated in time.
电力驱动的自上料搅拌车，配电设备应安装适当的熔断器及接地装置，以确保电气系统的。
The power distribution equipment of electrically driven self-feeding mixer shall be installed with appropriate fuses and grounding devices to ensure the safety of the electrical system.
自上料搅拌车在运行中，勿使砂石落人机械的运转部分中去，否则，零件易被卡住而损坏。
During the operation of the self-feeding mixer, do not let the sand and stone fall into the running part of the machine, otherwise, the parts will be easily blocked and damaged.
进料斗升起后，斗下不得有人通过或停留。
After the feed hopper is raised, no one shall pass or stay under the hopper.
自上料搅拌车进出料：
Feeding and discharging from the loading mixer:
出料前不能无故停车，亦不能加料后启动。入料量不能超过规定容量。
Do not stop without reason before discharging or start after feeding. The feeding amount shall not exceed the specified capacity.
搅拌工作结束后，要及时清洗自上料搅拌车，防止混凝土结块。清洗时，要防止电器设备受潮。清洗工作须在断电后进行，以防止触电。
After mixing, the self-feeding mixer truck shall be cleaned in time to prevent concrete caking. During cleaning, electrical equipment shall be protected from moisture. The cleaning work must be carried out after power failure to prevent electric shock.
每次充电前用水冲洗进料口，使进料口在充电时保持湿润；
Flush the feed inlet with water before each charging to keep it moist during charging;
装车的同时给随车自带的清洗水箱加水；
At the same time of loading, add water to the washing water tank provided with the vehicle;
自上料搅拌车装料后冲洗进料口，清理进料口附近残留的混凝土；
Flush the feed inlet after the loading of the loading mixer and clean the residual concrete near the feed inlet;
在施工现场卸料后，冲洗卸料槽，然后在混凝土储槽中加入30-40L的清洗水；车辆返回时，保持混凝土储罐向前缓慢转动；
After unloading at the construction site, wash the unloading tank, and then add 30-40L of cleaning water into the concrete storage tank; When the vehicle returns, keep the concrete tank moving forward slowly;
下次装车前切记将混凝土储罐内的污水排出；
Remember to discharge the sewage in the concrete tank before the next loading;
每天结束时，清洁混凝土储罐及进出口周围。自上料搅拌车的清洁点确保没有水泥和混凝土结块。更多相关内容就来我们网站https://www.jfjiaobanche.com咨询吧！
At the end of each day, clean the concrete storage tank and around the inlet and outlet. The cleaning point of the self-feeding mixing truck shall ensure that there is no cement and concrete caking. Come to our website for more relevant content https://www.jfjiaobanche.com Ask!
