自上料搅拌车厂家直销

品质创造未来,爱上中科聚峰造

全国咨询热线
400-879-1999
当前位置:首页 »新闻中心 » 行业动态炎热夏天使用搅拌车有一些“预防”措施

炎热夏天使用搅拌车有一些“预防”措施

来源:https://www.jfjiaobanche.com 浏览:0发表时间:2022-05-20
混凝土自上料搅拌车是一年四季都可以使用的机器。每个季节都有不同的使用注意事项。那么在炎热的夏天使用它应该注意什么?
Concrete self loading mixer is a machine that can be used all year round. Each season has different precautions. So what should we pay attention to when using it in hot summer?
夏季气温越高,燃油蒸发越快,容易造成阻气。因此,夏季需要及时清洗燃油滤清器。行车时,我们可以用湿布盖住燃油泵,定期喷洒,保持湿润,可以减少空气阻力的发生。一旦燃油系统被空气堵塞,我们需要立即找一个的地方停车降温,并拉动手动油泵给油路加满燃油。
The higher the temperature in summer, the faster the fuel evaporation, which is easy to cause gas blockage. Therefore, the fuel filter needs to be cleaned in time in summer. When driving, we can cover the fuel pump with a wet cloth and spray it regularly to keep it wet, which can reduce the occurrence of air resistance. Once the fuel system is blocked by air, we need to find a safe place to stop and cool down immediately, and pull the manual oil pump to fill the oil circuit with fuel.
夏季气温高,发动机容易过热。因此,在夏季,我们需要加强对发动机冷却系统的检查和维护,包括水箱、节温器、水泵、风扇等,并及时补充冷却水。当水温超过100℃时,我们需要将车停在阴凉的地方降温,我们可以掀开引擎盖散热。
In summer, the temperature is high and the engine is easy to overheat. Therefore, in summer, we need to strengthen the inspection and maintenance of engine cooling system, including water tank, thermostat, water pump, fan, etc., and supplement cooling water in time. When the water temperature exceeds 100 ℃, we need to park the car in a cool and safe place to cool down. We can lift the hood to dissipate heat.
混凝土自上料搅拌车厂家
夏季气温高,电池电解液中的水分蒸发快,液位迅速下降,缺水会损坏电池。我们需要及时检查电池内的液位,及时加入蒸馏水,保证液位正常,保证电池处于良好的工作状态。
In summer, the temperature is high, the water in the battery electrolyte evaporates quickly, and the liquid level drops rapidly. Lack of water will damage the battery. We need to check the liquid level in the battery in time and add distilled water in time to ensure that the liquid level is normal and the battery is in good working condition.
启动前,搅拌杆应处于中位,液压油箱油位应在规定范围内。启动后,先将操纵杆置于“卸料”位置,以排除搅拌筒内积水。装料时,操纵杆置于“装料”位置,调节搅拌筒转速。搅拌筒内的混凝土量必须符合运输车辆的规定。运输前,卸料槽必须锁定在“驱动”位置。运输时搅拌筒应低速转动。
Before starting, the mixing rod shall be in the middle position and the oil level of the hydraulic oil tank shall be within the specified range. After startup, first place the control lever in the "unloading" position to drain the accumulated water in the mixing drum. When loading, place the control lever in the "loading" position and adjust the rotating speed of the mixing drum. The amount of concrete in the mixing drum must comply with the regulations of transport vehicles. The discharge chute must be locked in the "drive" position before transportation. The mixing drum shall rotate at low speed during transportation.
作业结束后必须关闭内燃机,清洗料槽、搅拌筒进口和托轮,并混凝土结块。进入搅拌筒进行清洗时,取下内燃机电钥匙,锁好门窗,并在筒外设置监护人。操作完毕,将各把手置于中位,锁好门窗。
After the operation, the internal combustion engine must be shut down, the material tank, the inlet of the mixing drum and the supporting wheel must be cleaned, and the concrete caking must be removed. When entering the mixing drum for cleaning, remove the key of internal combustion engine, lock the doors and windows, and set a supervisor outside the drum. After the operation, put each handle in the middle and lock the doors and windows.
混凝土自上料搅拌车厂家提醒您,寒冷季节应采取防冻措施,化油器不宜用明火预热。在车下进行保养检修时,应关闭内燃机,拉紧手刹,并牢牢系住车轮。
The manufacturer of concrete self loading mixer reminds you that anti freezing measures should be taken in cold seasons, and the carburetor should not be preheated with open fire. When carrying out maintenance under the vehicle, turn off the internal combustion engine, tighten the hand brake and firmly tie the wheels.
炎热夏天使用搅拌车有一些“预防”措施的相关内容便是如此了,更多内容就来网站www.jfjiaobanche.com咨询吧!
There are some "preventive" measures related to the use of mixer in hot summer. For more information, please consult the website!