混凝土自上料搅拌车气缸常见的故障有哪些？
混凝土自上料搅拌车，气缸的功能是将压缩空气的压力能转换为机械能，气缸是混凝土搅拌站中保养和维修时容易忽视的一部分，下面混凝土自上料搅拌车讲一下气缸产生的故障及维修方法：正常情况下，气缸应随电磁阀电源的通断开关迅速到位；由于气缸活塞反复运动，则对缸壁及活塞进行润滑十分重要。由于气缸装配不当和长期使用，气动执行元件（气缸）易发生内、外泄漏，输出力不足和动作不平稳，缓冲效果不良，活塞杆和缸盖损坏等故障现象。
The function of the cylinder of the concrete self loading mixer is to convert the pressure energy of the compressed air into mechanical energy. The cylinder is a part that is easy to be ignored in the maintenance and repair of the concrete mixing plant. Next, the concrete self loading mixer will talk about the faults and maintenance methods of the cylinder: under normal circumstances, the cylinder should be in place quickly with the on-off switch of the solenoid valve power supply; As the cylinder piston moves repeatedly, it is very important to lubricate the cylinder wall and piston. Due to improper assembly and long-term use of the cylinder, the pneumatic actuator (cylinder) is prone to internal and external leakage, insufficient output force and unstable action, poor cushioning effect, damage of piston rod and cylinder head and other faults.
1、气缸出现内、外泄漏，内漏是指气缸活塞组件磨损严重，造成那个活塞前后窜气，影响气缸动作的快慢，严重时造成开关不到位；外漏是指活塞杆与气缸接触的端部密封件磨损严重而漏气，造成活塞杆回复速度慢，甚回复不到位。
1. The cylinder has internal and external leakage. Internal leakage refers to the serious wear of the cylinder piston assembly, resulting in the front and rear blow by of the piston, affecting the speed of the cylinder action, and causing the switch not in place when it is serious; External leakage refers to the serious wear and leakage of the end seal between the piston rod and the cylinder, resulting in the slow recovery speed of the piston rod, or even the recovery is not in place.
2、混凝土自上料搅拌车，气缸的输出力不足和动作不平稳，一般是因活塞或活塞杆被卡住、润滑不良、供气量不足，或缸内有冷凝水和杂质等原因造成的。对检查油雾器的工作是否可靠；供气管路是否被堵塞。当气缸内存有冷凝水和杂质时，应及时清理。
2. The insufficient output force and unstable action of the cylinder of the concrete self loading mixer are generally caused by the piston or piston rod being stuck, poor lubrication, insufficient air supply, or condensed water and impurities in the cylinder. Check whether the oil atomizer works reliably; Check whether the air supply pipeline is blocked. When there is condensate and impurities in the cylinder, it shall be cleaned in time.
3、混凝土自上料搅拌车，气缸的缓冲效果不良，一般是因缓冲密封圈磨损或调节螺钉损坏所致。此时，应更换密封圈和调节螺钉。
3. The buffer effect of the cylinder of the concrete self loading mixer is poor, which is generally caused by the wear of the buffer seal ring or the damage of the adjusting screw. At this time, replace the sealing ring and adjusting screw.
4、混凝土自上料搅拌车，气缸的活塞杆和缸盖损坏，一般是因活塞杆安装偏心或缓冲机构不起作用而造成的。对此，应调整活塞杆的中间位置；更换缓冲密封圈或调节螺钉。
4. The damage of the piston rod and cylinder head of the cylinder of the concrete self loading mixer is generally caused by the eccentric installation of the piston rod or the failure of the buffer mechanism. In this regard, the middle position of the piston rod should be adjusted; Replace the buffer seal ring or adjusting screw.
下一篇：水泥搅拌车储水罐加水操作步骤上一篇：平口搅拌车液压系统的保养要注意什么？
