水泥搅拌车储水罐加水操作步骤
一、控制好储水罐的气压经常紧固各个管接头
1、 Control the air pressure of the water storage tank and tighten all pipe joints frequently
水泥搅拌车罐体内应该打进多少的气压，这个在出厂的时候已经设定好，不需自己调节。如果遇上特殊情况非要调节，建议压力控制在3.5Mpa左右，压力太大容易爆管。另外，新的水泥搅拌车以及日常使用中，要对管路接口的地方随时紧固，防落。
How much air pressure should be injected into the tank of the cement mixer? This has been set at the time of delivery and does not need to be adjusted by yourself. If it is necessary to adjust in case of special circumstances, it is recommended to control the pressure at about 3.5Mpa. If the pressure is too high, it is easy to burst the pipe. In addition, in the new cement mixer and daily use, the pipeline interface shall be fastened at any time to prevent falling off.
二、水泥搅拌车罐车加水步骤
2、 Steps for adding water to cement mixer tanker
每种水泥搅拌车罐车加水处的布置都大同小异，一般都是水罐排气——加满水——关闭加水阀；在不用的情况下，需要将拨杆的位置放在中间。
The arrangement of the water filling place of each cement mixer tanker is similar. Generally, the water tank is vented - filled with water - and the water filling valve is closed; When not in use, you need to put the position of the paddle in the middle.
三、冬季排尽水泥搅拌车储水罐内的余水
3、 Drain the remaining water in the water storage tank of cement mixer truck in winter
在冬季，尤其北方的用户每天收车之后应该排尽水泥搅拌车水罐内和水管中的水，并在水管打入压缩空气吹尽各个管路中残留的水，防止因为结冰造成管路冻裂。
In winter, especially in the north, users should drain the water in the water tank of the cement mixer and the water pipe after receiving the vehicle every day, and inject compressed air into the water pipe to blow out the residual water in each pipeline to prevent the pipeline from freezing and cracking due to icing.
以上就是今天小编给大家提供的精彩内容，更多的精彩内容请点击进入我们的网站：混凝土自上料搅拌车厂家https://www.jfjiaobanche.com
The above is the wonderful content provided by Xiaobian today. For more wonderful content, please click to enter our official website: concrete self loading mixer manufacturer https://www.jfjiaobanche.com
下一篇：搅拌车如何更换液压油？上一篇：混凝土自上料搅拌车气缸常见的故障有哪些？
