中科聚峰

自上料搅拌车行业持续领跑者!

品质创造未来,让世界爱上中科聚峰造

全国咨询热线
400-879-1999

产品推荐

0.5方自上料搅拌机
0.5方自上料搅拌机
产品介绍:
1.2方自上料搅拌机
1.2方自上料搅拌机
产品介绍:产品型号:JBC-1...
1.8方自上料搅拌机
1.8方自上料搅拌机
产品介绍:参数说明轴距:2...
2.6方自上料搅拌机
2.6方自上料搅拌机
产品介绍:参数说明轴距:2...
2.6同步旋转自上料搅拌机
2.6同步旋转自上料搅拌机
产品介绍:参数说明轴距:2...
2方后置驾驶室自上料搅拌机
2方后置驾驶室自上料搅拌机
产品介绍:参数说明轴距:2...
3.5方D款自上料搅拌机
3.5方D款自上料搅拌机
产品介绍:参数说明轴距:2...
3.5方C款自上料搅拌机
3.5方C款自上料搅拌机
产品介绍:参数说明轴距:2...
3.5方B款自上料搅拌机
3.5方B款自上料搅拌机
产品介绍:参数说明轴距:2...
3.5方A款自上料搅拌机
3.5方A款自上料搅拌机
产品介绍:参数说明轴距:2...
4.0方自上料搅拌机
4.0方自上料搅拌机
产品介绍:参数说明轴距:2...
4方同步旋转自上料搅拌机
4方同步旋转自上料搅拌机
产品介绍:参数说明轴距:3...
5.5方自上料搅拌机
5.5方自上料搅拌机
产品介绍:参数说明轴距:3...
6.5方自上料搅拌机
6.5方自上料搅拌机
产品介绍:参数说明轴距:2...

资讯推荐

当前位置:首页 »中科搅拌机新闻 » 行业动态 » 全自动上料搅拌车在散热上的一些注意事项!

全自动上料搅拌车在散热上的一些注意事项!

来源:https://www.jfjiaobanche.com 浏览:发表时间:2020-11-20
中科聚峰厂家的全自动上料搅拌一体车中的散热器是非常重要的一个大件,散热器在使用的时候要注意一些事项。
The radiator is a very important large part in the automatic feeding and mixing integrated vehicle of Zhongke Jufeng factory. Some matters should be paid attention to when using the radiator.
1、备用的散热器有效环境应保持通风、干燥。
1. The effective environment of standby radiator should be kept ventilated and dry.
2、建议使用软硬水需软化处理后使用,避免造成散热器内部堵塞及水垢的产生。
2. It is suggested that soft and hard water should be used after softening treatment to avoid internal blockage and scale formation of radiator.
3、在冬季为防止结冰造成芯子破裂现象,如搅拌车长期停车或间接停车时,应将水箱盖和放水开关,将水全部放出。
3. In winter, in order to prevent core breakage caused by freezing, such as long-term or indirect shutdown of the mixer, the water tank cover and water drain switch should be set to discharge all water.
           中科聚峰厂家
4、水位计应每3个月清洗一次或视实际情况,各部件拆下用温水加无腐蚀性洗涤剂清洗。
4. The water level gauge should be cleaned every 3 months or according to the actual situation, all parts should be removed and cleaned with warm water and non corrosive detergent.
5、散热器内完全放水再注水时,要先将发动机缸体的放水开关扭开,有水流出时,再关上,从而避免产生水泡。
5. When the radiator is completely drained and then filled with water, the drain switch of the engine block should be turned on first, and then turned off when there is water flowing out, so as to avoid the generation of blisters.
6、在日常使用中应随时检查水位,要停机降温后加水。加水时,将水箱盖慢慢打开,作业人员身体应尽量远离加水口,以防高压蒸汽油加水口喷出造成烫伤。
6. In daily use, the water level should be checked at any time, and water should be added after shutdown and cooling. When adding water, the water tank cover shall be opened slowly, and the operator's body shall be kept away from the water inlet as far as possible, so as to prevent scalding caused by the spray of high-pressure steam gasoline.
7、散热器不应与任何酸、碱或其它腐蚀性性质接触。
7. The radiator shall not be in contact with any acid, alkali or other corrosive properties.
8、在使用防冻液,为了避免散热器的腐蚀,请务必使用正规厂家生产且符合国家标准的长效防锈防冻液。
8. In the use of antifreeze, in order to avoid the corrosion of radiator, please be sure to use the long-term anti rust antifreeze produced by regular manufacturers and in line with national standards.
9、视实际情况用户应在1~3个月间对散热器进行完全清洗一次芯体。清洗时,用清水沿反进风向侧冲洗。
9. According to the actual situation, the user should clean the radiator completely once every 1-3 months. When cleaning, wash with clean water along the side of the reverse wind direction.
10、在安装散热器过程中,请不要损坏散热带(片)和碰伤散热器,以保证散热能力和密封。
10. In the process of installing the radiator, please do not damage the strapdown (piece) and bump the radiator to ensure the heat dissipation capacity and sealing.
以上就是有关全自动上料搅拌一体车散热器的注意事项,如您想要了解更多资讯内容欢迎点击咨询我们的网站:中科聚峰厂家https://www.jfjiaobanche.com
The above is the notice about the radiator of the automatic feeding mixing truck. If you want more information, please click our website: Zhongke Jufeng factory https://www.jfjiaobanche.com 。